The cable set top box is red, and the green light is behind!
The set-top box is not initialized. Turn off the power. Or plug in the service card before you switch on. No, the set-top box is faulty.
The set-top box is not initialized. Turn off the power. Or plug in the service card before you switch on. No, the set-top box is faulty.
The set-top box is mainly because the red light signal source TV does not have the correct switching to the signal input mode of TV signal source has been switched to the set-top box, so the TV shows no signal, according to the remote set-top box also did not see any reaction.The solution is as follows:1, the TV remote controller at the television, according to the following TV/AV key switch television signal source for AV mode, can display the set-top box remote control screen, then use the set-top box, you can control the set-top box.2, if the TV set and set-top boxes are connected through the HDMI line, you need to press the TV remote control signal source will switch to HDMI mode to display the set-top box screen.3, the user can also directly press the TV remote control signal source key, in the pop-up signal source menu options, one by one to switch the signal source until the display set-top box screen so far.
