The first ice making is normal. After the ice removal, the second time no ice making, what's the matter?
. 5, condenser is dirty, high voltage protection. Two, ice production reduced by 1, capillary or expansion valve plug. 2, the system moisture is too high, there is a slight ice jam. 3, ice machine condensation system is blocked. 4 lack of refrigerant or leakage. 5 、 the evaporator is dirty. Three, wet Bing Bing film is not hard, 1, environmental temperature is too high, especially in the summer will have a kind of situation. The machine repaired 2, add refrigerant. 3, ice separator water supply is too large. 4, press power shortage. Four, the machine running, but not out of ice, 1, water disk water is not enough or anhydrous. 2, reducer failure or deceleration motor. 3, system failure, ice jam. Dirty block, etc.
Causes of ice making in ice maker and Inspection Notes: 1. Compressor work at break: 1, low voltage. Check the power supply. 2 、 handing over contact is not good. 3, system pressure protection. 4 compressor starter fault
5, ice thickness is not enough, five, ice machine leakage 1, the inlet valve to supply water disk is too large. 2 、 the connection pipe is broken. 3, fault. 4, water level float valve fault. Six, noise is too big, 1, ice maker fan fault. 2, reducer fault. 3 、 compressor noise. Seven, water shortage alarm 1, water supply joint filter screen plug. 2, water pipe plug. 3 、 inlet valve block. 4 、 drain valve leaking. 5 、 water pump failure. Eight, boot system failure 1, phase sequence problems. 2, the power supply system failure. 3 、 control panel fault
