The forklift truck is a motor vehicle solution
1, rated lifting weight: forklift rated lifting weight refers to the center of gravity to goods fork front wall distance not greater than the load center distance, lifting the maximum weight of the goods is allowed, expressed as a t (t). The weight should be reduced by the longitudinal stability of the forklift truck when the weight of the cargo on the cargo fork exceeds the specified load center distance.
The Angle of the door frame: the Angle of the door frame is that the unloaded fork of the forklift is on a flat, firm ground, and the door frame is the largest Angle of tilt forward or backward relative to its vertical position. The front rake is used to facilitate cross and discharge goods; The rear tilt is when the forklift truck carries a freight line, preventing the cargo from slipping off the fork. Before the general forklift Angle is 3 ° ~ 6 °
2, load center distance: load center distance refers to the goods on the pallet fork put standard, its centre of gravity is the arrival of the vertical section of the front wall of the horizontal distance T fork, expressed in mm (millimeter). For 1T to 4T forklift, the load center is 500mm. 3, maximum lifting height, maximum lifting height refers to the flat on the solid ground, forklift truck, loaded with goods rose to the highest position, pallet fork level on the surface of the vertical distance from the forklift truck's horizontal ground
It's a motor vehicle. It is only used for loading and unloading, and it is usually only in the factory area. All motor vehicles must be listed. Of course individual drive a factory to need to use forklift truck general is not to go up the list.
Forklift belongs to the motor vehicles: forklift industry carrying vehicles, refers to as a pallet for loading and unloading, stacking and short distance transportation of various wheeled transport vehicles. The technical parameters of the technical parameter forklift are used to indicate the structure and performance of forklift vehicles. The main technical parameters are: rated lifting weight, load, center distance, maximum lifting height, door frame, dip Angle, maximum speed, the minimum turning radius, minimum clearance from the ground and wheelbase, wheel track, etc.