I am trying to find a good drill for drilling into small pieces of sea glass,gemstones ,resin and metal. Please recommend a good affordable drill.
It's been reported that the fire resulted from some phone lines in a closetwhy set the white house on fire when a shredder is more efficient and less noticeable. Sometimes Sh*t happenslet's wait until the investigation is complete. Jumping to conclusions is never a good idea. I will reserve my opinion until all of the facts are presented and I have had ample opportunity to research the conclusions offered.
If this is the hot water tank temperature pressure relief valve drain line then by code it should be copper pipe no smaller than 3/4 inch in diameter. If you are getting hot water dripping from this line and it is connected to the TPR Valve then the valve is bad and leaking or the valve is doing its job and the water heater is malfunctioning and this is in turn a safety issue. Never cap off the outlet of a TPR valve if you do and if the water heater malfunctions, overheats or over pressurizes it could explode. This line might be your condensate drain line from your air conditioning unit. Best way to repair is to purchase elbow, two couplings and some pipe, PVC primer and PVC glue. Cut out old defective part install new. Use bleach water on mold and leave wall open a few days bleach will kill mold. Pipe and fittings should be minimum schedule 40 PVC pipe. Make sure all joints are glue joints and not compression couplings or unions. Do not install compression couplings or unions in the wall as this is against plumbing code. See link.
You'll have to cut out the elbow and replace with new PVC. Give yourself plenty of room to add a union (pipe to pipe) then another elbow (pipe-elbow-pipe) then another union, (pipe to pipe) Make sure to clean the PVC with the purple stuff and use the cement as directed.
