What are the requirements for plastic channel plate routing?
When the groove plate is butted, both the bottom plate and the cover plate are sawed into a 45 degree angle, and the seam of the bottom plate and the cover plate shall be staggered when installed. When the corner is connected, the inner part of the groove on the corner should be cut into an arc shape, so as to avoid damaging the wires when wiring.
Plastic board for dry field cooperation permanent wire laying groove plate wiring should be in the civil plastering dry after appearing, be close to the surface of the buildings to be flat vertical.
The spacing between the slots shall be less than 0.5m, and the starting point and terminal shall be fixed at the ends of 0.3m. The cross section of the groove plate wiring should be less than 6mm2, and the same circuit board can only be installed with the same circuit wire. The inner conductor of the groove plate shall not be connected with the wire joint in the junction box, and the slot plate wiring shall not be arranged in the wall and ceiling.
