Home > categories > Security & Protection > Heat Detector > What if lightning strikes a castle?
Question:

What if lightning strikes a castle?

It's like THE TALLEST thing in the entire area (like so tall it's scary). It's mostly just solid brick on the top though. So, should we put a lightning rod up there So it doesn't strike the castle? Any suggestions on what to do?

Answer:

most likely you have a loose hose. pop off the cover and take a look. there will be a drain hose from the induced draft blower and one from the secondary heat exchanger. both of these hoses will hook to a trap of some sort.. on rheem ruud and weather king itll be a round black box.. on trane and most others the trap will be rectangular and white..what ever the brand, the trap will be hooked into a drain, or condensate removal pump. if you are in serious doubt, get a carbon monoxide detector. there cheap, and they could save your life. if you call a service man, dont act panicky..a good service man can find a leak in a brand new unit.no liethey all leak a little, but they suck in fresh air rather than blow out fumes unless there is a serious hole or crack. rheem imperial drum units were a peice of junk and should be deep sixed as a matter of habit. hope this helps, Possum,hvac guy
the blower relays are bad on the control board. To get him by for now - take the motor lead going to the heat terminal on the board and place it on the HUM terminal, and remove the wire that is there if there is one. HUM is 120V hot output to the humidifier transformer if he has a humidifier. It will act similar to the blower heating relay sending power to the blower seconds after the burners light. The permanant fix will be a new circuit board, the a/c wont work until a new board is put in. Unless the blower is hard wired into the main line to run all the time. Don't try wire 120 V to multiple motor leads at the same time.
Hi, I went to wal-mart in got leather it was not that expensive. I got it to use to make a saddle for a wooden horse I made for my granddaughter. I would suggest going to wal-mart and looking for end pieces of leather.There usually marked down in price.Also check out other places that sell material.We have a JOANN Fabrics here and you can get a coupon for 40% off on 1 item.So you could get it really cheap if you have a store near you.Good Luck AS far as the shiny matteral your need ask someone at Hobby Lobby.If they don't have it ask them if they know where you can get it.

Share to: