I want to know what is the best car alarm system. I want to buy the best one that is hard for theives to steal the car or get close to it. and it doesnt alarm when it rain hard I also want to know if you put a new alarm, Does the old alarm steal works? Do i have to remove it when i install a new one? Can you steal use the stock alarm and armed it with the new ones?plss answer all of it thanks best answer get a highest points!!!
handlebars next to the door?- if theyre is no screw or bolt to acess from the outside, you will need to go from the inside by pullin off the plastic trim on the inside to find the screw or bolt. if inside the truck check the sides of the chrome plate and look for really small screws
1.You can produce severe burns in the skin, remove clothing is better, then a shower of emergency, and quite soap, if they become waste, use lemon or acid citrico diluted to remove the skin bases, and sodium bicarbonate to 10%, on the skin, whether it was acid. 2.called immediately to the 911, by precaution, only if a fire minor, then uses the fire extinguisher , and gives the alarm general to help you, to remove the solvents volatiles or explosives the path of fire. 3. in the laboratory there should always be as a measure of urgency, isotonic sterile solution of sodium chloride to 0.9%, several litres, you must uncover your or the closest to you, a liter, and wash your eyes immediately and long time, some 15 minutes at least. 4.You can use several materials: 1. Calcium dioxide if an acid, and catch mask for gases immediately. 2.wood dust crushed, if it is a basis. 3. sand from sea, dry, if it is a solvent dangerous. 5. After cleaning everything with plenty of water and detergent powder
There are a few more steps than you may imagine. First, the chrome trim on top of the headlight has to be removed as well because it is attached to the front side of the cover by a notched tab. To take off the trim strip, you must remove the headlight by removing the headlight trim ring and unscrewing the three screws holding the headlight bulb assembly. On the underside of the headlight nacelle near the front is a tiny nut attatched to the front mounting stud of the chrome strip on the top of the nacelle. Remove the nut and then slightly pry the halves of the nacelle apart. Then you may remove the trim strip by lifting it upward from the front, releasing the tab that is in the cover you are wanting to remove. Now, remove the trim ring from around the steering head lock, it is just plastic and will come up either by gentle prying with a screwdriver or by hand if you can get a decent grip on it. Under the trim ring are two phillips head screws that you remove. You can now take the cover off and use the proper allen wrench on the riser bolts. Now do everything in reverse to put the cover back on.
