Power cable in the cable tray is a single layer of laying, or can be stacked together with multi-layer laying?
There is no rigid requirement in this area ~ cable has no direct impact on the cable line ~ attention to the corner of the protective measures to do a good job. If you lay the cable line to meet the cable lines, other fiber optic lines or long-distance fiber optic lines, should try to walk in the top of the above position. You do not have to worry about the problem.
Width . high 400 such a bridge, the future replacement of the lower cable is too difficult.
N power supply is not enough, two methods. 1 for a separate power supply hub2 with a usb extension cable directly into the chassis behind, trick: your mobile hard disk should have two usb mouth and then, find a high-power charger on the line, that is, with usb That kind of mouth of the charger, remember is a high power, or give you burn the charger
1: hard drive power cord 2: hard disk data cable (CD-ROM data cable) 3: graphics cable cable (if your graphics card is dual 6PIN power supply interface, but your power supply is only a 6PIN power supply interface, then the root switch on the use of ) 4: hard disk data cable (optical drive data cable) 5: hard drive power cord two hard drive power lines were inserted mechanical hard disk and solid state hard drive, two data lines were inserted mechanical hard disk and solid state hard drive, graphics card power supply cable are generally not , Believe that your power supply supports dual 6PIN power supply interface.
