What is the reason that the valve is not used for a period of time?Anonymous browsing | 314 times
7, when installing check valve, should pay special attention to medium flow direction, should make medium normal flow direction and the direction of the arrow on the valve body is consistent, otherwise it will cut off the normal flow of media. Valve should be installed at the bottom of the pump suction pipe.The general formula 8, lift check valve should be installed in horizontal pipe, vertical lift check valve and bottom valve is usually installed in a vertical pipe on the road, and the bottom-up flow of media.9, the check valve closes, will produce water hammer in pipeline pressure, will lead to serious damage to the valve and piping or equipment, especially for the big pipe or high pressure pipeline, it should pay attention to those who use check valve.
4 the vertical lift check valve shall be mounted on a vertical pipe.5, the lift type horizontal check valve shall be installed on the horizontal pipe.6. Do not check the weight of the valve in the line. The large check valve shall be independently supported so as not to be affected by the pressure caused by the piping system.
1, the valve at both ends of the road must be blocked, there is dry ventilated room. Such as long-term storage, should always check rust corrosion.2, the valve should be cleaned before installation and eliminate the defects during transportation.3, the installation must be carefully checked on the valve signs and nameplates are in line with the use of requirements.
