What tools do you need to remove and solder this chip? Is it possible to have an electric iron and a tin screw? Don't use hot air guns
Integrated block, two back row. The technology is good, and can tin suctioner or tin solder cleaning line one by one after the removal of electric iron. However, if the original solder joint is very small and the holes and pins are tight, it is very difficult to remove the tin because it is difficult to clean. You can solder it at once with a hot-air gun.
Tolerable。On the chip pin, multi point solder, the iron should be dragged back and forth, and so on, one side of the pins are hot, gently move the small word, pull the pin out a bit, and then take the other side until you take down to.It can suck out the tin tin gun each foot, slowly put down the chip.
Tolerable。On the chip pin, multi point solder, the iron should be dragged back and forth, and so on, one side of the pins are hot, gently move the small word, pull the pin out a bit, and then take the other side until you take down to.It can suck out the tin tin gun each foot, slowly put down the chip.
