When milling a bit of a deeper corner, there are bullet and knife cuts, how to avoid it, and what factors are involved in playing with the knife? Is there a certain coefficient?
Slow down, cut less, you can turn the hole in the corner first and drill that arc out
4 aspects of the tool are taken into consideration: first, cutting parameters; second: machining allowance; third: tool holding length and elongation. Fourth: is cooling sufficient?.Because you said the processing is relatively deep, and for the Qing Kok, so the length and elongation of the tool clamping relationship is relatively large, and the coefficient of relations, such as drawings, hope to help you.
Corner machining allowance than other position to, cutter to the corner position, margin once more, and stretched out long cutter, inevitable play knife, avoid this situation is to use some of the cutter location, the corner position alone with small milling, machining processing volume small, slow speed.There is a direct relationship between the length of the tool and the length of the tool.
