Basically, a high speed drill, like those used for bone carving, is used to grind away a bit of decayed tooth. The tooth is then inspected using a dye or something that highlights decay. Then amalgam (?) is placed in the hole. What is so tricky? Why can't people just sepnd a month tarining to do fillings and then do them in 15 minutes for $20,
PVC or CPVC are both fine for potable waterthat guy is a dumb *** plumberYou should not use PVC if it is for hot water thoughYou need to cut the pipe where it was in the fittingbecause when you use PVC cement it melts the pipe and fittingthen when you put the two together and the glue sets up they are fused togethernow that it blew out the pipe and fitting are a bit smaller than originalit will still work..but to be on the safe side you should use a new fitting and clean pipejust to be on the safe side
Yes, and if you don't need safety glasses for sex you're not doing it right!
If condensation accumulates upon them, and vission is paramount to safety at the time, is it still accurate to call them safety glasses wouldn't they be endangerment glasses in that case?
No, it would be wisest to wear a straight jacket and sit in a padded white room at all times.
Sure and while you're at it, get those knee pads, elbow pads, face guard, bullet proof stab vest, groin protection, shin guards, leg guards, earplugs, nose plugs, helmet, wire mesh gloves, steel tipped shoes, and jump into a jumbo space saver bagand then, all your worries are over-
