Woodworking engraving machine how to use the tool can not be hurt to the table?
The second best in the engraving machine table with a protective plate, such as woodworking engraving machine vacuum table can be put on a thin plate Aosong on the table, Aosong board itself loose will not affect the vacuum adsorption capacity, can effectively avoid damage caused by inaccurate tool origin set table.Woodworking engraving machine table in use even if the treatment is still inevitable in the long-term use will appear accidentally scratch, this time on the need to re milling flat table, when the table with bakelite or PVC is too thin to re lay a layer of it.Also note that, when the machine factory, in order to prevent collision in logistics transportation of surface damage, usually need to customer service personnel on-site installation and commissioning of the new milling time table.
Then, according to the cutting depth set in the Thai region, the corresponding height is raised. Here, let the Z axis be zero again. This is the origin of the Z axis. According to the setting depth in the Thai Thai, engraving machine down to the lowest point is my family once a zero place, just on the top of the table, so that the material is fully engraved, and will not hurt the engraving machine table.
The first is the parameter setting problem when woodworking engraving machine in Z axis positioning, not let the knife touch material surface, but remove the materials for knife touch table, touch it, not deep, where Z first zero axis.
