Say a .22 round?This is hypothetical, of course.
just a sledge hammer should should work.
unless you entered in your OWN pin code, for most cell phone companys the pin code is either the last 4 digits of your , or 0000 otherwise you'll have to go to your local Sprint Coorporate store and have them help you. GOOD LUCK!!
Because the block is held together with silicone, it is a pre-assembled panel set in place as a complete unit. It is not stuctural and has no reinforcement or mortar in the joints. If time is not important, work the edges and try to get it out in one piece. In case of fire. Glass block is manufactured to have a core with a partial vacumn. When it breaks it will implode. Strike the block with a hammer dead center and break out the glass on your side only. Do not break thru the block yet. Do this to at least nine blocks. Sixteen is better if you have time or are large. Next start knocking out the glass between blocks starting at the bottom blocks and working your way up the hole. If you start at the top, broken glass will get in the way as you work down. Try not to break thru the block until the end so smoke does not come in. Have a blanket ready to crawl over. Expect to spend 2 to 10 min. doing the job. Depending on hammer size and your size. Remember: Break out the center of all the hole blocks. Then break out the thick glass that forms the grid starting at the bottom.. Finish breaking out the glass on the far side.. Put blanket thru hole and crawl out. Note; A 10 sledge, swung well, will take out the center of a block. Any hammer will do.
