Y38-1 gear hobbing machine how to process 46 teeth spur gear and how to change wheel

3 answer

Y38-1 hobbing machine processing 46 teeth spur gear method and how to hang wheel. Thank you

3 answer

When the new bevel gear is turning, it is loud and reverses normal

3 answer

What are the basic parameters of an English gear?

3 answer

What is the maximum force between two feet when an ordinary 45 normalizing gear engages each other without damaging the gears?

3 answer

How about the ignition time of the engine gear?

3 answer

What is the difference between the positive force and the reaction force of helical gears?

3 answer

Spur gear modulus 3, tooth number 12, addendum diameter 40, cross tooth number 2, cross tooth distance 13.789-0.03~-0.05, milling machine should be how deep?

3 answer

Measured straight tooth gear Z=27, outer diameter 114.2mm, root diameter 99.5mm, tooth all high 7.5mm, pressure angle may 20 degrees

3 answer

Specific selection of spur gear flow meter?

3 answer

Is the standard spur gear the same type as the spur gear?

3 answer

How can the gears be machined two times in line cutting?

3 answer

How about Victoria no formal gear

3 answer

What's the accuracy of the line cutting technology for machining gears (standard gear, spur gear)?

3 answer

What is the difference between bevel gear and reverse gear, in terms of noise, wear resistance and carrying capacity?

3 answer

Milling machine at most how many teeth can gear, ask God for help

3 answer

What is the difference between the correct gear meshing conditions for different types of gear drives (straight teeth, helical gears, bevel gears, worm gears)?

3 answer

The 100t-6 ignition time of fire plug to the point, it is toward the front gear arrow

3 answer

What is the function of the manual valve using the gear?

3 answer

L one CKC one 32 gear oil use

3 answer

Is the positive gear rotation and reverse gear, which is turning, noise is normal

3 answer

When measuring gears, why are they often measured near the high gear section?

3 answer

Knowing the center distance and the multiple of the two gears, the modulus and the number of teeth of the two gears (center distance 157.5) are 1.5 times the speed of the pinion

3 answer

There is a pair of spur gears, Z1=21, Z2=29, M=8, pressure angle =20 degrees, ha*=1, c*=0.25, required to be installed on the two axis of the center distance of 208MM, and the feet are required

3 answer

Three sets of gears with the same diameter of cylindrical gear, bevel gears and worm gear tooth which group can obtain larger output torque

3 answer

What is the difference between the valve drive gear and the handle?

3 answer

What is the driving of a gear?

3 answer