Home > categories > Automotive & Motorcycle > Axles > 2003 crown vic rear axles wont push in,why?
Question:

2003 crown vic rear axles wont push in,why?

I took my rear axle apart but I can‘t get the axles to go in far enough to remove the c-clips.I‘m thinking my rods are bent.I also took the ABS sensors off.what‘s wrong?

Answer:

Crown Victoria Rear Axle
May 28, 2018
If the oil leak's out plenty, it is going to reason your differential to apply up-lock up, because of the fact of certainty it desires oil for lubrication. Oil leaking on your brakes won't cause them to lock-up, in undemanding terms the alternative, they won't grab in any appreciate. If the leak is extremely small, and this is no longer effecting the brakes, in undemanding terms have the people who substitute your oil, to surprising it off each time you get your oil replaced. Now, why is it leaking? in the journey that your wheel bearings have wiped out and that's making the seal leak oil into the brakes, specific, you will desire to prefer to have it mounted maximum appropriate away, yet mutually as this is a gasket on the rear differential cover, that would no longer problematical to repair.or value that plenty.
May 28, 2018
You did remove the center pin, right?
May 28, 2018
OK this is easy the numbers the old way of describing tire sizes is the 3.00-17 and that means the tire has a cross section of 3 inches and is on a 17 inch rim . now the New way of describing tires is in metric and in millimeters. So to get a replacement tire for you bike take the 3.00 inch size and multiply by 25.4 that equals 76mm all the English measured tires are 80% tires meaning that the sidewall heigth is 80% of the cross section of the tire . so the metric conversion of your tire would be 80/80/17 as for a larger size on the rear compared to the front tire. look in your owners manual or on the sticker on the bike for the proper sizing for front and rear . there are some older bikes that had the same size tire on the front and rear . my 72 Moto Guzzi has the same size front and rear , so its not unusual . as for the Interior tire or tube the convention is to have it slightly smaller than the tire size since it is inside the tire . you can also look on the tube and it should say what range of tire it was designed for. hope this helps.
May 28, 2018
Also on the side it will say MAX PSI which is the most air you can put in it safely. See site below
May 28, 2018

Share to: