Home > categories > Packaging & Printing > Double Sided Tape > How do you apply double-sided adhesive tape?
Question:

How do you apply double-sided adhesive tape?

How do you apply double-sided adhesive tape?

Answer:

7, in the printing process to clean the printing plate, should avoid cleaning solvents, contact tape, so as not to damage the tape;8 when the plate is removed from the tape, the angle between the plate and tape shall be no more than 90 degrees.9, the interface version of the place to stay 5mm or so, the use of 3M 1600 electrical insulation tape seal version of the effect is good, you can effectively avoid wiping the plate caused by the interface version of the resulting ink pollution, and very economical.10, double-sided adhesive over repeated use can produce overprint bad phenomenon, especially in the new situation, and used for a long time in registering are likely to happen.
4. The joint of the double adhesive tape should be staggered with the joint of the plate;5, with adhesive tape, it is best to use rubber scraper, in a parallel sweep way, the tape evenly affixed to the roller, in the tape and the roller can not leave the bubble; (if the bubble retained, the application needle punctured)6, in determining the location of the printing plate, should avoid the printing plate and tape premature contact, to determine the printing position, remove the tape protection layer, the plate with rubber roll, in parallel with the way on the adhesive tape;
1, we put the plate, tape and paste roller at the same room temperature for a period of time before pasting;2, in the paste version, it is necessary to press the plate and affixed to the cylinder clean;3 if the plate is attached to the sleeve, the minimum air pressure must be used to prevent the sleeve from deforming;

Share to: