How does the belt of the fan adjust
Method 2: find a more a long straight plate, the length of the most like two pulley center distance is a bit long, this long established card to the spindle wheel, based on this board, adjust the motor wheel. Safety operating rules for wind turbines
If the motor belt is two, the outer belt is removed and removed from the smaller pulley Remove and remove the belt under the belt under the belt under the belt under the belt under the belt. The inner belt is removed from the inside.
Change of belt operation: The blower should be switched off before replacing the fan belt. 2, change belt need two to do the homework, and keep the lighting intensity on the scene (usually with the light, strong light, etc.). To loosen the positioning bolt on the base of the motor base with the appropriate club spanner or open wrench. Loose 4, close to the regulation of motor rotor side top wire fixing device, puts forward adjusting motor side top silk, the regulation of spacing between the motor pulley and fan pulley as possible (if a adjust the spacing between pulley is not small, but puts forward motor side control device, continue to adjust, until the right). If the motor belt is two, the outer belt is removed and from the smaller pulley
First, the condition of changing belt: The belt looseness is not consistent when the fan belt is properly adjusted. The belt is cracked or cracked. The fan belt is worn badly and the rotation is obvious.
Method 1: determine the principle of a straight line according to two points. Find a fine line, in one of the pulley of the lateral wall to find two points (literally sought, had better be to found in the direction of the belt), straighten, based on the line, you can know another pulley wall distance, how far this line distance adjustment. However, it is best to draw the line on the main shaft, because most of my years of experience have been turned off by the electric wheel.
