How to install CNC machine tool
Vertical turret mounting(1) open the guide strip and press plate on the cutter holder, clean the guide rail and the processing surface, check the guide rail surface should be intact without rust.(2) the left and right vertical turret respectively with lifting beam, with oil on the rail surface, the gear transmission is to mobile tool beam assembly hole, mounted on the plate, strip, slide clearance adjustment.(3) the vertical shaft of the vertical cutter head is installed, and the compression member of the balance hammer is removed, so that the counterweight is balanced.
You should first look at what products and processing process can be determined by what what tool, with a few knives, then you can choose to install the tool; we should consider the tool do not interfere in the process, should pay attention to the length of cutting machining depth and the selected is appropriate, but also note is the tip and selection tool the height of the knife is to be consistent, high attention to; such as your machine tool clamping position width is 64.0mm, then you must choose the cutter bar is 32.0mm, or the center of your nose is not high, so the processing will have a lot of problems; or you can according to the side making auxiliary tool carrier the installation is generally use screws; the cutter bar top dead on it
Side frame installation(1) remove the strip, the pressure plate, cleaning the guide rail and other processing surface, check the defect and put on the lubricating oil.(2) the connecting piece of the tool holder and the counterweight, such as the bearing, the pulley (or the chain wheel), the axle, the hanging rope or the chain, and so on.(3) the stone school F on the positive exploration in wood, clean school guide surface, with lubricating oil, the side head hanging on it, slowly close to the school with positive guide, strip, plate, preliminary adjustment guide clearance, connection lifting mechanism.(4) connect the counterweight and the side of the turret, rose hand operation knife, check whether there is blocked, demolition of timbers.
