How to paste the car counter cursor?How do I reverse the cursor on the van?
1. The body light reflection mark is made of red and white strips (specifications: 50mm, 75mm, 100mm) reflective material.2, the total quality of not less than 12000kg trucks and the total mass of more than 3500kg trailers should be set at the back of the body reflective logo, and the minimum height from the ground to 380mm. The car body reflective mark shall reflect the rear width of the motor vehicle.3, car is not less than 10m and the total mass of more than 3500kg truck trailer should be installed across the body reflective logo on the side, marking the conductor length should not be less than 50%.4, the vehicle has protective devices, can be directly affixed to the body reflective logo.
First of all, qualified car body reflective labels, in addition to 3C logo, the label also has the name of the manufacturer, origin, model, specifications. These 5 signs must be both indispensable.According to the relevant regulations of GA406 and No. 1 amendment list, etc.:1. The body light reflection mark is made of red and white strips (specifications: 50mm, 75mm, 100mm) reflective material.
5, the body can not be posted, it should be affixed to the lining board, and then mounted to the body.Example of van, low speed freight car, van, van TrailerThe side body reflective logo should be along the car under the edge paste, on the side of the upper part of the compartment side angle with white body reflective logo spliced into the "inverted L", "L" in the horizontal direction and the vertical direction by the white stitching unit with a length of 2 150mm and. The rear body light mark shall outline the rear of the carriage, and the four corners shall be joined by the white unit. Figure H.2 b) is an example of the two stage body light identification material. When using the first body reflective material, the four corners of the rear of the cargo compartment are outlined with white units, and other parts are intermittently pasted.
