Some trademark is very well, some one tear is to tear it off, but some torn the layer under the trademark adhesive didn't drop, just stick to the above, do not wash off, looks dirty. Again thanks in advance
wind In the high temperature disinfection disinfection ark, take out is a block, and need not to tear, is clean. This is because in the high temperature, in addition to special glue, expect ordinary rubber aging fall off easily.
Here I recommend two kinds of methods: one is the heating method, is to use hot water or heat blower lead to trademark label fall off; 2 it is online or entity shop to buy a bottle of anhydrous ethanol (high levels of alcohol) came back clean, the retail price is 8 yuan. I hope can help to you.
Directly use hair dryer blowing hot vestibule of glue will get inside, the edge of the label will be part of the cock, you can get down, the rest, if there is a trace, use detergent on besmear, and then rub with clean silk is ok! Remember that the whole process not to touch water!
In this paper on the bowls the non-drying label, removal methods are: 1, with hot blowing a little heat, jie in addition; 2, soak in hot water, after being soaked, also can easily remove; 3, if not too dense, slow operation, general can direct jie in addition; 4, a few drops of cooking oil, after being soaked can easily remove; 5, if have been removed, but not the stickers, can use alcohol to wipe, with the hand rub except; 6. Wind can erase 7. The car in addition to the asphalt, spray glue, a spray out, just finished a good cleaning
With strong adhesive labels, in plain English is also a kind of organic resin, organic matter and water is not compatible, so water is indelible, steel wire brush is hard to brush it off, with wine, vinegar, detergent, washing powder, soap, hot water wash not to drop, since the organic resin, it must to use organic solvent to wash. With ethyl acetate, butyl acetate, such as strong solvent that is very easy to wash, but it usually people don't. In fact side there is a commonly used organic matter, that is detergent. Not to say that just now detergent to wash not to drop? May be tried, with detergent to wash not to drop the glue. But if you don't water, pour the detergent directly on the glue, then use wire brush to brush, brush off easily, clean, very well. Original detergent is generally high alkyl sulfonate + trace surfactants, senior alkyl part is organic, and adhesive glue is dissolved, and sulfonate part is inorganic, so can dissolve in water; When you open after diluted with water, alkyl content is very low, and adhesive is not miscibility, so wash not to drop the glue; Do not add water, alkyl content enough, can be compatible with adhesive, so you can easily remove the glue. Give it a try. Is very effective. This answer adopted by the questioner
