Regulated power supply and load configuration
Regulated power and load configurations:
1, the load configuration can not exceed the output power of the regulated power supply.
2, the load equipment in reality can be divided into three categories: pure resistance type load, curve load (sense type or capacity type), non-linear load.
5, the power supply products can not be long-term full load with the load operation, must be in the power matching ratio on the left a certain degree of margin, generally to maintain a 30% margin more appropriate.
6, the power supply is stable for the load to provide a stable AC power supply or DC power supply electronics. Including AC power supply and DC power supply two categories.
3, the output power of the power supply products are generally measured in pure resistive load, and pure resistive load, linear load, non-linear load of the internal power factor is not the same, very different. Pure resistance type load power factor of 1; linear load power factor is generally 0.6-0.8, non-linear load power factor is generally seen as 0.2-0.4. So the power of the same power supply products can match the load of different nature of the maximum power is not the same.
4, the non-linear load power in the calculation need to be multiplied by 5 to charge the power supply load power, the linear load power in the calculation need to multiply by 1.5.
