About 10 seconds, there are 1 drops. Due to the previous installation and the present situation, the disassembly and dynamic welding can not be performed and the water can be cut off for a short time. Is there a good way?
What is the pressure in the pipe? The glue material is not blocked up, in the humid environment and water under the condition that the glue is not stick, reliable and economic way: cold metal flux were patching, simple and convenient, do not need what tools
You this kind of circumstance belongs to leak, general silk can be screwed down to replace. This situation should be installed when the seal is not handled properly. Do not want to move pipes, only with special glue to stop the leak. Many local hardware market, directly tell him what material, you know what glue to you.
1) want to save trouble, buy special glue to block, general hardware store can buy;2) the silk joint opens, the more winding some raw rubber tape, then turns tight to see whether can solve the problem;3) if it is a silk joint, replace the wire joint;4) the pipe is re tapped or replaced with a new pipe;
