What are the differences between the products made of wrought round steel and hot rolled round steel and tested by mechanical testing after heat treatment?
Hot rolled round steel products made in forging round steel, this is because of forged steel ingot is as equivalent to the blooming state of the existing semi finished steel. Its structure, properties and impurity content are far below the quality level of hot rolled round steel.
The longitudinal and transverse properties of the free forging or hammer forgings are relatively small, the banded structure is not obvious, and the plastic inclusions are less deformedIt is not suitable to use rolled material for the workpiece with higher requirement of transverse or tangential performanceSampling position should be the same, usually in accordance with standards or technical requirements, such as vertical performance of a three pull, take at 2/3R
In comparison, the general longitudinal performance of hot rolled round bar is better than that of transverse or tangential direction, and the difference between the two values is obvious. The banded structure is more obvious in the longitudinal microstructure, and the deformation of non-metallic plastic inclusions is more obvious
