What's the problem with moisture in the floodlights?
Materials to be used: LED guardrail light clip, transformer with water proof function, sub controller, steps as follows:1, install guardrail, punching on the wall, spacing according to actual requirements, usually in 3 cm;2, do anti-static measures, such as work platform to ground, workers wear the corresponding electrostatic clothing, anti-static measures, because different grades of LED floodlight quality is different, antistatic ability is different;3, installation pay attention to sealing, sealing is not good, diameter affects the LED floodlight service life;4, LED flood light wiring is best not more than 25 centimeters, transformer power can be larger, or else affect brightness.
Be careful1, try to use series LED form, because the LED floodlight voltage difference is special. The peak current of the common LED is maintained at 80 Ma and the reverse voltage is up and down at 6V. In the LED application, the peak voltage and current at the limit shall be considered when designing the circuit.2, when using 25 Watt welding voltage, electric iron temperature controlled at 300 degrees Celsius in the high temperature state of SMD LED, do not squeeze epoxy resin part of it, or wipe with sharp objects, because the LED lamp is very fragile, easily damaged, welding time is 3 seconds.LED flood light is widely used, so the installation skills and precautions are very important, LED is a new light source, in the right way to install, to ensure that LED floodlight stable long-term normal work.
Floodlights illuminate objects evenly from one particular point to the other.If there is a condition, aging and sealing of semi-finished products, there is another key is to control the temperature and humidity of the workshop. If you cooperate with some big international manufacturers, you are required to control them. Individuals have done energy-saving lamps, lamps and lanterns also have such problems, the problem is always in the summer, autumn, winter less. LED lamps have also seen, usually the evaporation of silica gel and parts of the surface and air moisture (summer, autumn, air moisture), temperature and humidity can be controlled at 25 degrees 60% below
