I have been with my girlfriend for four years and if we have a terrible argument and I end up making her cry, I feel like the biggest bastard and try to apologize and comfort her, but whenever I try to, she locks herself in the bathroom for over an hour and avoids speaking with me. Half the time I sit there by the bathroom door, waiting so I can fully apologize and after wards she doesn't try resolving anything or explaining what I did wrong to upset her and she just goes straight to bed leaving me baffled and unsure of what to do next. Why does she do this? It makes me feel so helpless half the time, because I really dislike upsetting her and seeing her cry.She does the same thing if I watch a movie with her, where she finds it heartbreaking. She'll quickly rush off into the bathroom and then a minute later she'll come out and it'll be obvious she was crying and she'll deny it. Do you think she just doesn't like showing her feelings in front of me?
you can buy a set of manifold guages online. - typical high side pressure (thats the smaller line) will range between 200 - 300 psig. Depending on the outdoor temperature. Instead of reading the pressure on the gauge read the temperature / number on the inner dial for R-22 that correlates to the pressure. That number should be 20 to 30 higher than whatever the outside temperature is. Low side should read between 60 to 70 psig depending again what the temperature is inside. - No. No static pressure test. the units needs to be running and the conditions should be atleast 70 F outside. And checking pressures alone will not tell you if the systems charged or operating correctly. A superheat check will give you an idea. Take the temperature of the suction line / larger pipe minus the pressure/temperature of the coil. Ex. 50 F line - 70 psig (roughly 40 F, found on the inner dial thats green) 10 F superheat. This is only enough to give you an idea, a good superheat check alone will not tell you that the systems is charged correctly, ecspecially if there is a TXV. Pressures, temperatures, superheat, subcool, will all very based on conditions (outside temperature, indoor wet bulb, airflow) Pressure and temperature readings which may be acceptable one day may not be another day as conditions change. When hooking on your hoses bleed the air out at the ends, and if you don't have low loss fittings expect to loose apprx. 3-5 ounces of refrigerant when you take off the high side which will be liquid refrigerant spraying out for a few seconds, so be sure to wear gloves, or learn how to recycle the refrigerant back into the low side from the high side before taking off your hoses.
it can be caused by lots of things wires shorting out fuel pipe leaking ect and as long as it is insured with at least third party fire and theft the insurer should pay u will no its on fire when you see the smoke just before the flames lol
you decide on a set of tension gages for it once you are trying this ,you may desire to have extra freon than you have tension,and which will reason an in-stability interior the device,and not enable it to kick back genuine good,that's why air con artwork could desire to be left people who try this for all time,it is going to hold relating to the comparable quantity of freon ,yet without the gage on it,you will possibly not get it to kick back precise,there ought to be plenty tension on the extreme edge of it,and much on the low edge,if not it wont ever cool precise,in case you get too plenty in it,it may desire to lock the compressor up on it additionally,good success with it.
