Woodworking engraving machine when carving, Y axis serious jitter, stuck
In case of power failure, push back and forth to see if the rack and pinion wheel buttons are tight enough to make the gap. Then, switch to another drive to see if there are any problems. The presence is not a drive problem, and the absence of the drive is a problem.
It may also be Weihong card problem, you can put the machine stop off, but it must not operate the machine back to the origin, directly set the processing position to start processing line.
1, check the Y shaft drive systemUsually with impurities or lack of oil2, switch drives and motorsDetermine the fault point3, there is a problem with the knife path, reducing the F value
