Home > categories > Automotive & Motorcycle > Axles > 1980 Honda Accord CV joint/axle assembly?
Question:

1980 Honda Accord CV joint/axle assembly?

My 1980 Honda Accord CV joint is making alot of loud clicking noises. So i have a few few questains.How much would a new on cost? I have been reading about it and it says i should just buy a new CV axle.Where can i buy one?Where can i go to get it fixed and how much would labor cost at a shop?Can i do it myself?how do i grease it?And finally ho far can i drive on it before it goes out? I need to drive from San Luis Obispo California to Ventura California. About a three hour drive. I need the answer ASAP. Thank you.

Answer:

buy a new axle yes cv joint is same thing axle 200 bucks or about to buy part can get at most parts stores as for how much a shop might charge should cal three local shop ask cant say when if might fail only that it will possible to replace it at home yes if your handy with tools not a big job can find a how to type into search box how to replace how to remove how to install cv joint how to remove cv joint how to remove cv joint video how to remove cv joint 1980 Honda Accord cant say if you can drive three hours or three weeks but knowing its bad good reason not to drive it at all but it might make it or you might end up on side of road waiting as well takes a few hours to do it myself with right tools nothing Special needed
Disk brakes aren't worth a flying f*() after about 5 years. Things get corroded and don't release.
My guess is that the seals inside the caliper cylinders have picked up so much dust that it has jammed the pistons, you will need to completely strip down and service the caliper and replace the seals – do not scratch the bore.
They're usually a little over $100 They can be purchased at any auto parts store You can do it yourself with basic tools and common sense Once it starts clicking, you can't save it by greasing it
You can buy Orginal equipment parts, which are more expensive, or after market parts, or re manufactured parts. Call a local parts supplier like NAPA, Autozone, etc and check the prices of their replacement parts. Then call a few shops and get a quote on replacing the part with them supply the part, or you supply the part. Ask if they are using OE, Re manufactured or after market parts. You can save a LOT of money by going to a reputable independent shop.

Share to: