Home > categories > Home & Garden > Blocks & Roll Bags > CNC turret is also called the sender sensor
Question:

CNC turret is also called the sender sensor

CNC turret is also called the sender sensor

Answer:

The rotation of the NC turret is positioned by induction.
It can be said that the signal is used to change the knife
No, the inductive switch is only one of the components of the sender. Each unit corresponds to a Holzer sensor, along with the knife on the knife body rotation, the switch will be close to the magnet Holzer signal. What is the location of the knife to tell the host. The white piece fixed on the edge is a magnet. The middle line is the sensor. Together, they constitute a communications disk.
The transmitting disk is provided with an inquiry, a tool holder switch, an electric knife holder, and a protection circuit, which is composed of a diode (1) and a RC filter circuit which are connected in series, and the RC filter circuit is composed of a resistor (a) and a capacitor (3). The protection circuit of the utility model is connected in series with the all signal output end of the electric tool from disk, can prevent the destruction of the DC power inverter and switching overvoltage, harmonic voltage and instantaneous current impact, the input power series protection circuit of the utility model, can ensure that the sending disc Holzer element operation point. The working principle of the switch is similar to that of the inductive switch, but there are differences. Please accept the answer!

Share to: