The length of the guide and lead screw of the XY worktableIs the guide rail longer than the lead screw or the two supporting end of the screw? Can it be considered as the length of the lead screw?That is, if you specify that the range of travel is x to 250 y to 200, then should I choose x 280 or 520 for the length of the rolling guide?
Generally speaking, the wire rod is longer than the guide rail, but this one has no hard and fast requirement. The length of the screw depends mainly on its working length (the length of the tooth)
According to the working table for machining, rail length table must be greater than the screw length, the length of screw stroke by the table to determine the stroke length + + screw nut screw length = table super length + end; rail length = table travel + working table length + super.
The distance between the two ends of the support is the length of the lead screw, but you should find the bearing position at the supporting end, and the step position at both ends of the screw, which directly affects the installation position of the screw nut seat. If you have any questions, ask me the D rail must be longer than the lead screw
