When pasting, use the scratch cards to scratch it slowly. The introduction book of the OK8 stick membrane teached me like this. Pay attention to gently scratch the bubbles when pasting. Sometimes when you wipe the screen clean, there is no need to scratch. There will not be bubbles because of electrostatic adsorption.
1. The environment: the place that need to be pasted with film should be bright enough. And the ligh indoors is too weak, the table lamp should be prepared so as to look the details clear. 2. To wash hands: The dust and grease on your hands should be cleaned carefully.
1. The environment: The place that need to be pasted with film should be in the bright light. If the indoors' light is too weak, then the small table lamp should be prepared to looke the details clelight is bright enough, indoors if too black is ready to small table lamp, light enough to see details. 2, wash their hands: First, clean up the dust and grease on the hand. Pay attention to use the liquid soap to wash. 3. Wiping the screen: Wipe the screen with a special fibre screen cloth, general senior film have specialized attached, if there is no can also replaced with glasses cloth or dropping the soft cloth, dip a small amount of water or special screen cleaning agent to rub, to clean up the clean surface dust, fingerprints for quasi. 4. Begining to paste: The tab 1 The thin?film is the protective layer rather than the using layer. To tear off the label from table 1 slow, then align the up and the left of the screen and paste it on. 5. The process: When pasting the film, keep a constant speed. And when there are appearing bubbles, please pull back and ensure no bubble on the surface. Then scraper the blade with wool scraper or cushion. You should scratch it slow to avoid damaging it. To press the surface of the mobile phone, the instant bubbles will be very small. 6. To repair: After pasting, and then make a restoration of the bubble in some areas. Use the hard card and credit card, just wipe the card with the soft cloth and slowly scratch the bubble out of. If there are any small dust particles on the surface, please uncover the block and paste it up with the adhesive plaster, and then paste the stick membrane well. If the good paste screen is only with only tiny bubbles, it generally disappears within a week automatically.
