What steel blade drill bit, hardness above 60
Hello, it is recommended to use steel bit, two hundred to three hundred RPM (8mm below the hole, 8mm or more to reduce the speed), pay attention to cooling, the amount of feed should not be too large. For reference only, I hope it will help you.
A diamond bit is a drill bit for cutting edges. The drill bit is an integral bit, the whole drill bit has no moving parts, the structure is relatively simple, with high strength, high wear resistance and impact resistance, it is one of the three new drilling technologies in the world in 1980s. Field use shows that the diamond bit in the soft - hard strata drilling, have the advantages of high speed, more footage, long service life, stable operation, less accidents, downhole wellbore quality etc.. The diamond bit not only can be used for a long time, but also can be reused. The diamond bit recovered from the factory can be used almost as well as the diamond bit produced by the factory. It can save drilling cost in large amount.
1, steel blade with steel drill bit.2, steel alloy steel is a kind of complicated, containing tungsten, molybdenum, chromium, vanadium carbide forming elements. The total amount of alloy elements is about 10 to 25%. It can maintain high hardness at high temperature (about 500 DEG C) in high speed machining, and HRC can be higher than 60. This is its main characteristic - red hardness, which can be used to make cutting tools. The Rockwell hardness of tungsten series and molybdenum high speed steel can reach over 63 after proper heat treatment. Because the steel is too hard, so can not bend, a love fold, it is difficult to punch.
