Why does the water softener rush out of the resin?
Water softener regeneration of resin, mainly from the following aspects: the backwash resin is mainly because there is no installation of water distributor, backwash flow, the expansion of resin space is small. If the new equipment is normal, a small amount of broken resin flow out, it is a normal phenomenon. The solution of a large number of outflows is that the water distributor can be installed, or a limiting hole on the backwash water pipe is blocked, and the backwash water flow is reduced. Henan Dachuan water treatment is very happy for you to answer
Therefore, the general installation of the normal work of water distributor (so that the backwash flow is uniform, will not cause excessive local water, out of the resin!) Backwashing flow control appropriate (not too large), the water softener above the expansion of resin space to increase (ie appropriate to reduce the amount of resin), can solve this problem.
I think the second answer is reasonable: water softener regenerated resin, if it is a small amount of fine resin is the normal phenomenon (because the water softener after normal operation, the resin particle diameter because of water erosion gradually decreases! Remove this part of the resin when washing back, otherwise it will cause the running resistance of water softener to increase
