i have a 2005 jeep wrangler, and when i tried to install the front sway bar links, the stud on the links snapped when i was ratcheting the nut on. i slipped the stud through the mounting hole, and then i used a ratched to get the bolt on. the stud was not totally through the hole, but i figured i could get it all the way through when i tightened the nut down. should i have done this with the front of the car up on a jack? i never did this project before. thanks in advance
Vishal, you didn't say whether these detectors are part of a security system. However, if they are, there is a program error in the system that needs to be reset or a fault in the system that the security company needs to address. Otherwise, If these smoke detectors are stand-alone, then I can't figure out why or how they're beeping. If you remove the back-up batteries and cut the power, then the detectors have to stop (zero power). Since you replaced the detectors, I doubt they're both faulty. good luck
This I hope they can help because your Kindle Fire sounds pretty hosed to me. If they cannot help, then if your Kindle is under warranty, see if will replace it with a refurbished model. Just say it got into that state by itself.
