Home > categories > Security & Protection > Smoke Detector > How do I replace a door on a 1999 Chevrolet Tahoe?
Question:

How do I replace a door on a 1999 Chevrolet Tahoe?

My boyfriend slid into a fire hydrant and the passenger side door needs to be replaced. Anyone know where to find an installation guide or can help? Thanks.

Answer:

Only if they were anti fog, on the inside too of course. They'd also need a safety strap in case of high wind.And the edges would need some rubber trim to stop the plastic making marks on ones skin around the eyes.
After cleaning it I suggest you take sand paper and very lightly roughen up the surface a little just so whatever paint you decide on with adhere better. I recommend spray paint. There are tons of colors and it's made to stick to all surfaces well. that way you 'll avoid brush strokes and /or roller marks. I did this to my kitchen table and chairs and was very happy with the outcome. Just make sure your hand is in constant motion and at least 6-8 inches away from the surface you are painting at all times. Do many light coats so you get an even finish.
If your smoke detectors are hard wired you must turn of the power since you're going to have to disconnect and reconnect the wiring.
if that's not the right one just type in smoke detector

Share to: