A S195 diesel engine has changed main shaft, main shaft tile, engine oil pump, connecting rod tile, engine oil also does not burn, engine oil power is also new, half an hour indicator will not come up, beginning indicator pressure is very enough. No, the spindle will go down in 5 minutes. It has been broken several times. You've been driving for ten or twenty years. Can you do me a favor?Don't pull up indicator will score, gear edge
I said immature advice, look at the body, the oil pump oil process hole is not exposed gas?. The phenomenon of air exposure must be reflected in the engine oil bubbles. Open the front cover, rotate diesel engine, find oil, solution,
Spindle mounting is not accurate, or the main bearing cover on the location of the crushing of the Ding, so that the spindle displacement caused by.
The only reason the indicator does not come is that the oil pressure of the indicator is not enough. According to this principle, the reasons for insufficient oil pressure are eliminated one by one. It should be noted that the replacement of new parts may not necessarily be good. As long as the oil pressure is not enough, or the oil pump problem, or the problem of oil, or that there is a certain place of normal leakage of oil, causing the arrival indicator oil pressure is small.First make sure the oil pump, the method is very simple, to another machine try glance. When installing the oil pump, be sure to pay attention to the leak. Check whether the oil is fake and shoddy. By the way, check the indicator and you'd better change it to another machine. If the above is no problem, you can basically determine the normal leakage of oil. For many reasons the oil leakage is very complex, with the main bearing and the crankshaft, the new fit is not necessarily good, with the clearance of additional oil, there is the crankshaft oil plug, whether tightening. As long as you check the oil path carefully, you will find the cause of insufficient pressure.
